I'm looking to make a Train Yard. Basically a double track with splitters to make it have a middle section that is 4 wide. Does anyone know the angles of curved track needed to make it connect back up?
Basically, you have a straight that goes into a splitter, and makes a side track. That curves back into another splitter down the line to return to a straight piece.
Thanks!
Quick Correction for total length is 70" not 90" - Sorry about that! (It's been a long day!)
Hi Ryan! I apologize, I was hoping to get to your message yesterday but I needed a moment to make a diagram to make sure I was understanding your setup correctly.
If this is what you're aiming to accomplish, the part IDs and quantities are below: Straight x12 Part ID FST (or QST for QuickTrack) 12 Degree Left x6 Part ID F12L (or Q12L for QuickTrack) 12 Degree Right x6 Part ID F12RÂ (or Q12R for QuickTrack) F Adapter x2 Part ID FAF (or QAF for QuickTrack)
Short Straight Track F x2 (This is a new part, I've added it as an attachment)
Part ID FSF (or QSF for QuickTrack)
Switch Track Left x2 Part IDs 3S1, 3S2, 3S3, 3SM Switch Track Right x2 Part IDs 2S1, 2S2, 2S3, 2SM A few notes: - You'll need your WarEngines outfitted with the WildTrack conversions to take the tighter 12 degree tracks. - The pieces assembled as shown span about 70". (not 90"! sorry about that) I hope this helps! Please let me know if I misunderstood or if there's something else that you need. Would love to see your setup once its complete! -Cassidy